4 tips for troubleshooting your marine transducer

Follow these tips when troubleshooting your transducer!

There are few boat accessories that can be more useful than a marine transducer, particularly when you're piloting your boat through an area where surface depth can fluctuate quickly. However, like any piece of marine electronics, they can give their owners problems if they're old or they weren't installed properly.

If you have a transducer and fishfinder but you find that they don't seem to be working for you, here are a few troubleshooting suggestions:

  • Be careful about interpreting depth readings when you're near another vessel. If their transducer is transmitting at the same frequency, it could be interfering with yours and producing inaccurate results.
  • If you have an outboard motor, make sure your transducer is installed closer to your starboard side. Your propeller can make it difficult for the transducer to take accurate readings of the bottom, so it is critical to make sure they're situated as far away from each other as possible.
  • Should your transducer cease to give you any reading at all, it may need to be cleaned. Make sure that any barnacles, seaweed or other material is removed so that it isn't obstructed when taking readings.
  • When you're piloting through shallow water and you have a high-powered transducer, make sure that you turn off automatic sensitivity and instead adjust it manually.

If you think it's time to replace your transducer and install a more powerful unit, make sure to purchase your new one from ePal. We have a wide selection of marine equipment from the best manufacturers, including Lowrance, Garmin and Raymarine. In addition, we provide the best shipping deal in the industry, with free ground shipping to the lower 48 states!

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>